Industrial Manuals

This document is about the technical parameters of 2N3418, 2N3419, 2N3420, 2N3421, 2N3418S, 2N3419S, 2N3420S, 2N3421S, including maximum ratings, working temperature range, package type, etc.

File format: PDF Size:49 KB

The FLQ series of fuses have a rated voltage of 500 volts and a rated current of 1/10 to 30 amps. They have a 135% current rating and a maximum opening time of 1 hour, 32/10-30 amps have a minimum opening time of 12 seconds, 200% current rating and a minimum opening time of 5 seconds. The fuse is listed by Underwriters Laboratories and certified by CSA. It has a rated interrupting current of 10,000 amps and a rated voltage of 500 volts.

File format: PDF Size:32 KB

This document is about the technical data of B57660 glass encapsulated sensor. It mainly introduces the features and characteristics of the product, including application areas, characteristics, specifications, and appearance dimensions.

File format: PDF Size:62 KB

FJNS4203R is a PNP epitaxial silicon transistor with low power and high frequency characteristics. It is suitable for applications such as switching circuits, inverters, interface circuits, and driver circuits. Additionally, it features a built-in bias resistor.

File format: PDF Size:37 KB

The document describes the features and characteristics of the MICROMASTER 440, including installation, commissioning, control modes, system parameter structure, troubleshooting, specifications, and available options.

File format: PDF Size:2242 KB

This data sheet introduces the Microchip Technology Inc. PIC16C641, PIC16C642, PIC16C661 and PIC16C662 microcontrollers.

File format: PDF Size:635 KB

This is a DC-DC converter produced by Tokyo Electric Industry, with model CEE98. It has a maximum operating frequency of 500kHz and a maximum operating power of 1.1W@100kHz, 2.8W@300kHz and 4.2W@500kHz.

File format: PDF Size:99 KB

This product is a IEEE 1394a-2000 fully compliant controller that supports 100/200/400 megabits per second of transmission speed.

File format: PDF Size:1614 KB

This file introduces the features and characteristics of the TSB12LV32 TSB12LV32I product, which is a general-purpose link-layer controller that is compliant with IEEE 1394-1995 and P1394a and can be used for computer peripherals and consumer audio/video electronics.

File format: PDF Size:86 KB

SLLS418I is a 1394 interface chip produced by TI, supports 1394a-2000 standard, supports connecting multiple devices, and has automatic power-off and low power consumption.

File format: PDF Size:970 KB

This document describes the issue of disappearing IDLE in Beta systems and provides a workaround

File format: PDF Size:24 KB

TSB15LV01 is a video signal processor integrated with a 1394 link layer controller from TI. It supports multiple CCD sensors and can be used in PC video camera, video conferencing, video capture, still picture capture, set-top boxes, video phone, gaming, webcam, robot, security and other fields.

File format: PDF Size:75 KB

This document describes a slight potential for PHY lock-up in a receiving node (including a repeating node) when a peer node is powered off or unplugged while transmitting data to the receiving node. If node B is unplugged or powered down while transmitting, its peer node A could see corrupted data on its port's twisted pair lines during the unplug or powerdown sequence. A rare condition has been discovered in which the node A PHY has the potential to enter a lock-up state after receiving a particular sequence of corrupted signals on the twisted pairs during unplug or powerdown of node B as node B is transmitting. Node A does see the bus reset event caused by the unplug or powerdown of node B but does not complete the collection of valid SelfID's. When in this state, the node A PHY is unaware of and does not respond to the bus reset caused by the plug-in of a new node C (or to the power-up of node B), this causes the just-connected node B or C to continuously issue bus resets. This causes the entire network to cease to function until the node A PHY is hard reset or disconnected from the network. This condition has never been reported in normal use; rather, it was observed in rigorous lab testing. All future releases of these devices shall have this issue fixed.

File format: PDF Size:24 KB

The TSB82AA2 OHCI-Lynx is a discrete 1394b link-layer device from TI, which supports PCI burst transfers and deep FIFOs.

File format: PDF Size:163 KB

This document introduces TI's FireWire® devices, which are compliant with the 1394b standard and advance home networking and high-speed data transfer. The 1394 (FireWire®) connectivity technology enables simple, low-cost, high-bandwidth real-time data connectivity between computers, peripherals, and consumer electronics. These devices are suitable for consumer electronics such as camcorders, A/V receivers, SACD and DVD-audio players, DVCRs, digital TVs, computers, and peripherals. 1394-compliant products offer consumers a quick way to transfer large amounts of data between components and create robust, high-speed connections between devices throughout the home or office. The original specification, 1394a, called for data transfer rates of 100, 200, and 400 Mbps over a distance of up to 4.5 meters.

File format: PDF Size:61 KB

This document describes the features and characteristics of a product, including support for IEEE P1394b Revision 1.33+, interoperability with Firewire, i.LINK, and SB1394, support for multiple transfer rates, and energy-saving features.

File format: PDF Size:1038 KB

This document describes the features and characteristics of VLCF series SMD inductors, including miniature size, high magnetic shield construction, and applications in portable DC to DC converters.

File format: PDF Size:32 KB

optris ® CT is a precise non-contact temperature measurement device that can measure temperatures from -40 to 900°C. It is one of the smallest infrared sensors in the world with 20:1 optical resolution, rugged and usable up to 180°C ambient temperature without cooling, separate electronics with easy accessible programming keys and LCD backlit display, optional analog output: 0/4-20 mA, 0-10 V, K or J type thermocouple, optional USB, RS485, RS232 interface or two optically isolated relay outputs, installation of up to 32 sensing heads.

File format: PDF Size:227 KB

This document is a specification for the MC24021A series products, including mechanical data, absolute maximum ratings, electrical characteristics, optical characteristics, etc.

File format: PDF Size:649 KB

This document provides specifications and characteristics of the PC1602LRU-HWB-H LCD display module.

File format: PDF Size:795 KB